How to use your Puffco Proxy?
The proxy takes roughly 90 minutes to charge.
Charge your Puffco Proxy before using it.
Charge your Puffco Proxy using only the provided USB-C charger and cable. The Proxy takes roughly 1.5 hours (90 minutes) to charge. Triple clicking will show you your remaining battery percentage.
How to turn on/off Puffco Proxy?
Hold the button down for 3 seconds to turn on the device.
Blue is the lowest, white is the hottest, single click to toggle between settings.

Hold the button down for 3 seconds to lock the device down in between uses.

How to Load Wax into Puffco Proxy?
Cold load your proxy before heating up, and be careful not to over pack to avoid leakage into the base.

hold the device upright and vertical
during use and inhale gently for maximum
vapor production

How to vaping with Puffco Proxy?
Place the carb cap on the top of the chamber.
Double click to initiate heat up pulsing light indicates the device is heating up.

Puffco Proxy takes approximately 30 seconds to fully heat the device will flash and vibrate three times when ready.

Hold the device upright and vertical during use and inhale gently for maximum vapor production.

How to Boost mode with Puffco Proxy?
Double-click to boost which increases heat and extends your session.
Do not initiate heat up more than four times consecutively.

How to Clear the Puffco Proxy?
Be sure to clean your chamber and carb cap after each use.
Wipe the chamber gently in a circular motion avoid applying excessive force or pressure when cleaning.

Clear chamber tips:
Make sure contents are still warm while cleaning.
This will help avoid potential issues that may reduce the life of the chamber.

How to check the battery of Puffco Proxy?
Triple clicking will show you your remaining battery life percentage.